Computer not recognizing Fuze when I installed Rockbox.

[chaoz]

I'm on Fuze v2, using the latest stable Rockbox. My computer won't recognize the device when I plug in the usb when the Fuze is on, so I have to turn it off first. It then recognizes the device but I think it's loading to the original firmware; I don't see any files at all.

Any help on this? I'm on Windows 7.

[CrowdAds]

[Marvin the Martian]

Originally Posted by chaoz

I'm on Fuze v2, using the latest stable Rockbox. My computer won't recognize the device when I plug in the usb when the Fuze is on, so I have to turn it off first. It then recognizes the device but I think it's loading to the original firmware; I don't see any files at all.

Any help on this? I'm on Windows 7.

That's how it works at this point.....you have to boot to the original firmware to connect. You need to check, in the original firmware, your USB mode.....make sure it is set to MSC, not Auto-defect....and you may have to remove your files from it and re-load them in MSC mode....after that, all should be fine.

[chaoz]

That did the trick. Thanks.