android
Go Back   abi>>forums > General Audio > Headphones

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 06-08-2010, 02:47 AM
invinciblegod invinciblegod is offline
Junior Member
 
Join Date: Aug 2007
Posts: 7
Default Replacing the TRRS Plug on my phone headset

I am currently trying to replace the plug on my headset for my blackberry.

I bought a replacement trrs plug and cut the wires out of the plastic. As shown in the diagram below, the wire colors are blue, red, green, copper, and a red and copper twist.

I found a diagram that says that the headset plug from the tip to the sleeve is left, right, ground, then mic.

So far, after testing, I found out that i get audio out of my right earphone if i put green/blue on B and blue/green on C. I get another channel of audio if i put green/blue on A and blue/green on C. I also get audio if i put green/blue on B and blue/green on A.

I don't know which of the A,B,C,D corresponds to tip, ring, ring, and sleeve. I could not find a datasheet anywhere. I also don't know what the wires correspond to. I believe the untwisted copper wire is ground, the red is MIC, the twisted copper/red is MIC BUTTON, and the red and blue are speakers. I must be wrong though since I cannot get audio out of one of my speakers. I also find it strange that when I was testing, I could switch around the green and blue wires.

Any advice? Thanks.

Reply With Quote

Advertisement [Remove Advertisement]

 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT -5. The time now is 05:30 AM.