Firmware installation process

[jbob182]

I have dug into the exe of the latest firmware and have done some modding. The new form looks like the image attached to this post.

This exe will install the latest firmware just fine without any problems ( I tested it ) and it will show the steps it takes to update the firmware.


Download: Mediafire

*******************WARNING**************************
The "Format Data Area" button has not been tested, caution is advised.
It should just do the same thing as a recovery mode format
************************************************** ***

[Brett_val]

So what did you change? Or does it just show the steps? - which may be handy when the original firmware updater fails at some point and you want to troubleshoot it.

[jbob182]

So what did you change? Or does it just show the steps? - which may be handy when the original firmware updater fails at some point and you want to troubleshoot it.

The Only change is that it shows the process nothing else. It would be almost impossible to make a drastic modification to the installer because when a c++ application compiles, alot of the original source is lost.